Alcatel XFP Bedienungsanleitung PDF herunterladen (Seite 14)

Provisioning Requirements

Page 14 7210 SAS-M 10-GBase MDA

Provisioning Requirements

To configure MDAs and ports, you must be able to access the router by console or Telnet

connection. Refer to the hardware installation guide for information and instructions.

The MDA slot and type must be provisioned in order to configure ports. A port cannot be

configured until the MDA is provisioned.

Provision components in the following order:

Step 1 Configure the BOF parameter use-expansion-card-type to m2-xfp.

Step 2

Configure the BOF parameters no-service-ports to any two ports that you do not

intend to use.

Step 3 Slot number

Step 4 Type

Step 5 MDA slot number

Step 6 MDA type

Step 7 Ports

Component Power Consumption

Note: The above two steps can be performed from the Timos CLI prompt under the bof>

CLI context, in which case the node should be rebooted for the BOF parameters to take

effect. Additionally, the node can be rebooted and the above BOF parameters can be

modified during bootup. In either case, this is one-time configuration required for the first

time before the user can use this MDA.

Table 2: 7210 SAS-M MDA Component Power Consumption

Component Conservative Estimate

(Including Approx. 20% Margin) (Watts)

MDAs:

M2-10GB-XFP 15

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Alcatel XFP Bedienungsanleitung Seite 14