Installation Procedures
Page 20 7210 SAS-M 10-GBase MDA
Removing an MDA
Figure 2: Removing an MDA from the Expansion Slot
To remove an MDA:
Step 1 Disconnect all cables from the MDA ports.
Step 2 Loosen the MDA captive screws.
NOTE: The MDA cannot be removed if the captive screws are tightened.
Step 3 Slide the MDA out of the expansion slot.
Step 4 Place the MDA on an anti-static surface.
Step 5 You must either immediately install another MDA into the slot or replace the MDA slot
with blank cover
Kommentare zu diesen Handbüchern