Alcatel 9000 Betriebsanweisung PDF herunterladen (Seite 448)

100

101

Configuring Authenticated Ports Configuring Authenticated VLANs

page 22-28 OmniSwitch 6800/6850/9000 Network Configuration Guide June 2006

Port Binding and Authenticated VLANs

By default, authenticated VLANs do not support port binding rules. These rules are used for assigning

devices to authenticated VLANs when device traffic coming in on an authenticated port matches criteria

specified in the rule.

You can globally enable the switch so that port binding rules may be enabled on any authenticated VLAN

on the switch.

The port binding rule types that are allowed on authenticated VLANs are as follows:

• MAC-Port-IP address

• MAC-Port

The MAC-port-protocol, MAC-IP address, port-IP address, and Port-Protocol binding rules are not

supported on authenticated VLANs. In addition to the above binding rule types, however, a MAC range

rule may also be applied to authenticated ports. For more information about port binding and MAC range

rules and how to configure them, see Chapter 9, “Defining VLAN Rules.”

To enable port binding and MAC range rules on authenticated VLANs, use the avlan port-bound

command with the enable keyword.

-> avlan port-bound enable

This command allows some port binding rules (MAC-Port-IP address, MAC-Port, Port-IP address, and

MAC-Port-Protocol) and MAC range rules to be used on any authenticated VLAN.

To disable port binding rules on authenticated VLANs, use the disable keyword with the command:

-> avlan port-bound disable

This command disables port binding rules on all authenticated VLANs.

Configuring Authenticated Ports

At least one mobile port must be configured as the physical port through which authentication clients

connect to the switch.

To create a mobile port, use the vlan port mobile command.

-> vlan port mobile 3/1

To enable authentication on the mobile port, use the vlan port authenticate command:

-> vlan port 3/1 authenticate enable

For more information about the configuring VLAN ports, see Chapter 7, “Assigning Ports to VLANs.”

By default, authentication clients cannot traffic in the default VLAN for the authentication port unless the

avlan default-traffic command is enabled. See “Setting Up the Default VLAN for Authentication

Clients” on page 22-27.

1 2 ... 443 444 445 446 447 448 449 450 451 452 453 ... 701 702

Kommentare zu diesen Handbüchern

Keine Kommentare

Alcatel 9000 Betriebsanweisung Seite 448

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Alcatel 9000