Alcatel 9000 Betriebsanweisung PDF herunterladen (Seite 46)

100

101

Setting Ethernet Parameters for All Port Types Configuring Ethernet Ports

page 1-10 OmniSwitch 6800/6850/9000 Network Configuration Guide June 2006

As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet

before the slot number. For example, to administratively disable port 3 on slot 2 and document the port as

Gigabit Ethernet, enter:

-> interfaces gigaethernet 2/3 admin down

Configuring Flood Rate Limiting

The following subsections describe how to apply a peak flood rate value to limit flooded traffic (see

“Flood Only Rate Limiting” on page 1-10), limit multicast traffic (see “Multicast Flood Rate Limiting” on

page 1-11), and configure the flood rate value for an entire switch (slot), a specific port, or a range of ports

(see “Configuring the Peak Flood Rate Value” on page 1-11).

Flood Only Rate Limiting

The peak flood rate value is always applied to flooded traffic. However, it is also possible to apply this

value to limit the rate of multicast traffic on any given port (see “Multicast Flood Rate Limiting” on

page 1-11). The interfaces flood command automatically disables any multicast flood rate limiting on a

port so that the peak flood rate is only applied to flooded traffic.

Note. Note that the interfaces flood command is only available on OmniSwitch 6800 and 6850 switches.

In addition, the interfaces flood multicast command can also disable multicast flood rate limiting and is

available on the OmniSwitch 6800, 6850, and 9000 switches.

To specify flood only rate limiting for a single port, enter interfaces followed by the slot number, a

slash (/), the port number, and flood. For example, the following command applies flood only rate limit-

ing to port 2/3:

-> interfaces 2/3 flood

To specify flood only rate limiting for a range of ports, enter interfaces followed by the slot number, a

slash (/), the first port number, a hyphen (-), the last port number, and flood. For example, the following

command applies flood only rate limiting to ports 3 through 4 on slot 2:

-> interfaces 2/3-4 flood

As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet

before the slot number. For example, to apply flood only rate limiting to port 8/24 and document the port

as Gigabit Ethernet, enter:

-> interfaces gigaethernet 8/24 flood

To configure the peak rate value used for flood only rate limiting, see “Configuring the Peak Flood Rate

Value” on page 1-11 for more information.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 701 702

Kommentare zu diesen Handbüchern

Keine Kommentare

Alcatel 9000 Betriebsanweisung Seite 46

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Alcatel 9000